Fixes For some legacy post processors, error messages referenced outdated installation media, for example, DVDs. This reference has now been removed. (Carveco only) The Rope Creator no longer shows [...]

New OneFinity Post-Processors We now support the Onefinity Elite Series powered by their new MASSO controller. These post processors are Onefinity Elite (mm)(*.nc) and Onefinity Elite (inch)(*.nc).We have also created [...]

Fixes 3D Design: In v1.38, a rare bug was introduced that caused the Shape Editor to fail to generate a shape when supplied with certain 2D vectors. This has now been [...]

New: Post processors: Felder Hammer HNC - INCH (*.nc) and Felder Hammer HNC - MM (*.nc) post processors have been added. Fixes: Saving toolpaths: When working with the Open toolpath folder after saving option enabled, [...]

General Fixes Since v1.34, saving toolpaths with a post-processor that uses the ROTARY_AXIS_DIALOG statement would result in an error message. This has been fixed, and the Diameter For Rotary Axis dialog is now [...]

General Enhancements Trace around designs faster than before: We have increased the rate at which you can trace around part or all of an image or relief, owing to [...]