Fixes
- Toolpaths: Vertical plunge or retracting moves are now handled correctly to avoid gouging your material when using the Fluting toolpath. (All variants)
- Simulation: Previously, when you used the Simulation Control bar to review your toolpaths, the cutting tool and simulation of the cut material were out of sync. This made it more difficult to determine if and where a mistake may have taken place. This has now been fixed. (All variants)
- Post-processors: We have amended the
Datron Simpl V2 mm (.simpl)post processor so that your machine is now given the correct material size. This has been done by amending the WorkpieceGeometry line of code used to identify the top of your block of material. (All variants)
